Cerberus Pin

How to use

1. Clean surface of any dirt or dust.
2. Remove the paper backing by peeling away the transfer tape. The transfer tape will hold the individual pieces of the sticker in place while you position it onto the surface.
3. Apply transfer tape onto your surface to adhere it.
4. Use a credit card or squeegee to apply pressure to the entire design to make sure its fully adhered and to remove any air bubbles.
5. Slowly peel the transfer tape away at a 180 degree angle to leave the sticker adhered.
6. **Do not peel too quickly as the sticker may stay stuck onto the transfer tape if not careful.

Follow the stardust and you might find the angel at the end! ✨

1.5" Gold Plated Metal Pin 
Nickel Hard Enamel 
Rubber Backing

Is it a banana? Is it a bird? We'll just never know! 

Banana Bird Hoodie is screen printed with water based ink on a gold/yellow hoodie

*Sizes are unisex fit, please allow 1-2 cm size variance
*Garments are measured on a flat surface

Wash & Care

• Made of 8 oz., 50% cotton 50% polyester
• Wash cold inside out with like colors
• Hang to dry

What that dog yapping about?
 
1.5" Dyed White Metal
Black Soft Enamel
Rubber Backing

6" x 2.5"
Weatherproof and waterproof vinyl decal sticker
Used for outdoor or indoor purposes

How to use

1. Clean surface of any dirt or dust.
2. Remove the paper backing by peeling away the transfer tape. The transfer tape will hold the individual pieces of the sticker in place while you position it onto the surface.
3. Apply transfer tape onto your surface to adhere it.
4. Use a credit card or squeegee to apply pressure to the entire design to make sure its fully adhered and to remove any air bubbles.
5. Slowly peel the transfer tape away at a 180 degree angle to leave the sticker adhered.
6. **Do not peel too quickly as the sticker may stay stuck onto the transfer tape if not careful.

Bee with a knife! He's angry and gassy!!

1" Enamel Pin
Gold Plating
Black Rubber Backing